Hi all,I have a problem getting my ASA 5520 boot properly. I first though of a flash problem and did a flash erase in ROMMON, then it brought error 15 during boot (No images found in / Error 15: File not found). I then TFTPied and image from Rommon, ...
Hi all,I have a central site with few remotes sites connected this way: 1) A pair of Cisco ASA 5520 deployed in ACTIVE/PASSIVE redundancy at the edge of all sites including the central 2) ALL sites are interconnected by VSAT via the central...
Hi guys,I have a central site interconnecting 8 remote sites with a VSAT based infrastructure. A small office (with its own data and voice subnets) is linked to one of the remote sites via a radio link and connects to other sites through it.The probl...
Hi All,Am experiencing a problem with my telephony network consisting of satellites site with CCME and a central site with CCM 4.1. Intra sites calls go fine, but inter-sites calls ring, get connected when picked up but no voice can be heard.This is ...
Hello guys,I need your help on a problem I am facing with my PSTN incoming calls via bri. Whenever an incoming gets picked up, it drops before the first 30 second.The ouput ISDN Q93 debug showing call log from connexion to disconnexion is attached.I ...
Hi Dan,Both can have the same subnet mask but that doesn't matter in your case. Subnet mask has more to do with the size of networks or segments and obviously the system depends on how many hosts will be in each subnet, not forgetting to take in acco...
Hi Mike,Thanks for the suggestion. I actually tried that but nothing came up, when I connect back to then console after leaving the system on for a long time, nothing displays; but when I power cycle the system, then it displays the boot up process o...
Hi there,Is there a reason u want access originating from outside to go straight to the inside IP. By nature, ASA wouldn't allow a connexion from outside interface to terminate on an inside IP as if the traffic originated from the inside (That's noth...
Hi Mike,Thanks for replying. What I mean by seamless switchover is that when the primary link (primary Internet route via the loca ISP) goes down, their is no switchover to the secondary route for Internet via the VSAT.The VPN comes up allright when ...
Hi allThank you all for the replies. As Dennis said it was indeed a routing problem because for no obvious reason, networks that are statically configured with a /16 mask were showing up in the routing table with a /24 mask. I couldn't get a clue of ...
