Hi, i have few questions about pkg file when install new IOS1.request platform software package clean switch all file flash: This is the command to remove pkg files in order to free more mem for installing.i want to pre-load bin file to the s...
Hi, I just upgraded 3850 stack switch with 5 member from 16.9.8 to 16.12.7. After reload, the master switch has solid amber light on all four: Syst, Actv, XPS and S-Power. tried reload couple times; also tried to remove the switch out of stack ...
Hi Gurus, I have a L2 stack switches and every member has a uplink connect to a L3 switch. When the inbound and outbound traffic go through between L2 and L3 switches, does it go through all the links between them or only active switch in t...
Hi, i'm trying to use "wr erase" command to erase all the config, but after reload. I can still see the previous stack switch provision, vtp setup and vlans. Does anyone know the reason? Thanks
Tried it today. When remove package, Cisco knows which packages are being used and will NOT remove them. So it's safe to remove packages and free up mem. Then copy bin file to switch before the maintenance window.PS 3850 firmware version is 16.12.x
Very interesting. After a while when it's in standalone mode, it's automatically reboot and went into factory reset mode. I did emergency install, then everything is ok. Joined it back to the stack, then reload entire stack again, the "broken" switch...
Thanks ya'll for the answers. What's the reason not use etherchannel? could be avoid bottle neck? If L3 switch only has 10g uplink to router, and we have 3 L2 stack switches and each has 4 members, then the total of each stack has 4g link to L3. Tota...
