Hi,Simple question - can hsrp track two ip addresses? Meaning it tracks the first ip address first and then the second ip address, and if both ip addresses are unreachable, then hsrp will kick in.Regards
When we update the ospf redistribution command, should we completely remove the existing ospf redistribution command and then add the new command as below?router ospf 100router-id xx.xx.xx.xxredistribute odr metric 1 metric-type 1 subnets ...
Hi,When we add "ip host hostname ip-address1 ip-address2...ip-address8", will this run as sequential order?Meaning the ip-address1 will always be the highest priority and if it is not reachable then go to ip-address2 and so on...http://www.cisco.com/...
Hi,Is it possible to config different e&m signalling (as below) from the same E1 controller?controller E1 0/1/0 framing NO-CRC4 clock source internal ds0-group 0 timeslots 1 type e&m-melcas-immed ds0-group 1 timeslots 2 type e&m-immediate-startThanks...
Thanks.What is the command to show the DSP module/slot/version etc? I have the below output.Does it mean the router below has no DSP modules installed?Regardsvoicegate-1#sh voice dspDSP DSP DSPWARE CURR BOOT P...
