gjohnson1963

Add the weight to both providers and removeddefault routes. Looks like it's working.Thanks

I have 2 inputs for my internet link they are both the same speed. The config was setup for load bal...

I have a PIX firewall V6.3 and a Windows 2000 IAS to authenticate VPN(Client Cisco V 4)users by a Gr...

Removed the defautlt route on FastEthernet solved the problem.ThanksGeorge

I am running a multi-homed BGP setup with 2 different ISP’s each a full T1.On is connected serial th...

ThanksChanging the IP route from fastEthernet 0/0 to the next hop address on the Ethernet port worke...

I have to Internet connections with diffirent IPS providers, one is connected to Serial the other co...

I am have to different ISP and planning to setup BGP for load balance and fault tolerance on incomin...

It looks like what I want to do is Load Sharing Multihomed with 2 different ISPs whith one local rou...

I just purchased another T1 from second ISP for backup and if possible do some kind of load balance....

I am in the process of ordering a second full T1. I would like to load balance the traffic on the tw...

Scott I got it to work by changing nat (d-priv) 0 access-list nonat to nat (d-priv) 0 access-list vp...

ScottI made the changes and still not working. Here are the full configs, maybe I am missing somethi...

Scott, I had no luck, here is my configs.515:PIX Version 6.3(3)interface ethernet0 autointerface eth...

I have a PIX 515 and PIX 501with a VPN tunnel between the twoI have no problem accessing ether site ...