About kevtown

kevtown · 05-12-2003

I am having a problem establishing an IPSEC connection to an extranet through an IP NAT overloaded interface.On my intranet I have a workstation running Cisco VPN Client version 4.0.1. The workstation is routed through a Cisco 1601-R Router (IOS 12....

kevtown · 02-27-2003

There are several geographically separated intranet network access servers that route to each other via GRE Tunnels. Each NAS has the ability to static Dial-on-Demand route to several of the same extranet NASs via asynchronous analog modem connecti...

kevtown · 02-24-2003

I know that it is possible to reverse-telnet to a specific serial port on some routers by telnetting to a specific tcp port. For example:to reverse-telnet to Interface Async 5 with a tty line identifier of 5 you would telnet to the routers local IP a...

kevtown · 02-20-2003

I need help configuring NAT on a Cisco 1710The two interfaces being utilized areint FastEthernet0description connected to primary local area networkip address 172.16.11.1 255.255.255.0int Async5description PPP connection from remote-users and extrane...

kevtown · 05-20-2002

I am attempting to enable a Cisco 1710 to do Backup DDR to a Cisco AS5200 that is also being used to provide 56K analog connectivity to remote users. The problem is that upon establishing a connection, the AS5200 assigns the line an ip address from...

kevtown · 02-25-2003

Thank you ebergquist. This is exactly what I was looking for.

kevtown · 02-24-2003

Thanks gfullage,The part of the solution you suggested using NAT overload is basically what I tried. It does work but unfornately it does require that I mark the actual inside port as outside and vice versa which I had hoped to avoid.For some reason...

kevtown · 05-20-2002

Thanks for your help actually I had done this and placed the dialer map under a dialer interface. The problem was that I hadn't associated the dialer interface and the asyncronous interface to the same dialer group. Rookie mistake I know. Anyway it...

kevtown · 01-11-2002

Actually it doesn't work every time. On some devices you need the "Enterprise" image if you wish to support more than 5 vty lines.Here is my source for this info.http://www.cisco.com/warp/public/129/28.shtml#4

kevtown · 12-31-2001

Hi Thanks all for replying.The reasons for the complications and access-list is that I am looking to have remote users be able to dial-in and use the same modems to perform dial-on-demand routing to customer extranets.I have actually resolved the iss...

Member Since	‎01-29-2001 07:45 AM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	17

User Statistics

User Activity

VPN Client 4.0.1 to PIX 6.3.1 through NAT overload

Outbound DDR problem

Telnetting to specific vty port

NAT overload and host portion preservation

Override DHCP for DDR

Re: Telnetting to specific vty port

Re: NAT overload and host portion preservation

Re: Override DHCP for DDR

Re: More than 5 line vty on a 3640 router

Re: Loosing Route to Remote Client (Take 2)