We are about to change our ISP and the public IP address of our FMC will change, I have all my sensors registered over internet.  Should I have to re-register all the sensors or is there a way to edit some config and make it work?

How can I configure Firepower to detect inbound exploits i.e., if somebody is trying to exploit a known vulnerability to the box itself or to a resource exposed to internet. We have Firepower 6.5 and various version of ASA

Our current setup using ASA and Firepower Inside : 20.20.20.0/24Outside : x.x.x.x My access control policy is such that it inspects 'Inside' to 'Outside', where 'Inside' is Firewall trusted interface, and 'Outside' is Outside interface. I understand ...

We are using ASA and Firepower for internet filtering in Data Center. Our requirement is to control internet access on 'Need basis' only -- Allow what is required and block everything else, this includes the servers. So far so good. We are trying to ...