I have a Cisco 1721 Router and I am looking to monitor it for hourly statistics to find max and min speeds. How would I go about doing this? I know if I do a show interfaces it shows me all the data since the last time the counters were reset. Tha...
I have two 1721 Routers that are connected via a point to point T1 which connects into a WIC 1DSU T1 card on each of them. We have had our T1 go down twice and both times one of the routers needs to be rebooted to allow traffic across the network. ...
I have a Cisco 2650XM and a Multitech 820 and I am wondering if any one has any experience getting a VPN up between the two types of routers? Attached is the IPSec setup screen for a multitech.Any Ideas?
I'm trying to set-up a VPN between two 2600 routers. On router1 the ip address is 192.168.7.1 On router2 192.168.6.3. For testing purposes I have a 1700 router in between them and they are connected with T1 DSU/CSU WIC Cards with crossover t1 cabl...
I am trying to get a hardware VPN up between a Cisco 2650XM and a Multitech 820 router. Is this something that would be possible using IPSec and 3DES or AES-128? I'm new to the Cisco VPNs and if this is possible how would I go about programming the...
Sorry for taking so long to get back to you. I've attached a picture copy of the setup for router one and two. The IOS Version is 12.2(4)YA2, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1) at both ends.
The version I have does support IPSec because I have a VPN up between two cisco routers with this version: flash:c2600-jk9s-mz.123-17c.binWhat is the pfs?Thanks so far
My MTUs are set-up at 1500 bytes.The other question that I have is now that I have the VPN set-up between the serial ports, can I get my inside networks off the fa0/0 to see each other. When I try to ping them they say destination host unreachable.T...
What is the interface mtu? I'm a little confused with that. I'm guessing I don't have it set then.192.168.7.2 is the ip address of one of my T1 cards of my middle router between my VPN. I set it up with two 2600 series attached to a single 1700 se...
The VPN is up and running thank you. My next problem is the following error message occurs in SDM when I check the tunnel:Failure Reason:A ping with data size of this VPN interface MTU size and 'Do not Fragment' bit set to the other end VPN device i...
