About jdrurycisco

jdrurycisco · 06-11-2010

I am in the middle of my N1k upgrade and seem to be stuck. I have upgraded both VSM's with no issue. After notifying the vCenter server and accepting the upgrade, I tried the "vmware vem upgrade proceed" command and keep hitting the attached error....

jdrurycisco · 08-01-2011

SSH to your 6120connect local-mgmterase configurationThis will reset the 6120 to factory defaults after a reboot.

jdrurycisco · 06-26-2010

Go into the BIOS of the server and disable quiet boot. Once this is done reboot the server and enter the LSI config during the boot process. I think it is a ctrl-S to get into the LSI config. Once you are in the LSI config you can set the RAID lev...

jdrurycisco · 05-11-2010

Yes the uplink ports need to be connected in order for your vNIC's to work. Also I noticed that your vNIC is not set as a trunk and is only accessing the MGMT vlan. If you want your ESXi host to access multiple VLAN's you will need to set this as ...

jdrurycisco · 05-11-2010

You need to connect the uplink ports on your 6100's. The management ports are only for KVM or IPMI access to the blades. They will not supply connectivity for the vNIC's. Your ESXi install is attempting to connect to the network via the vNIC's. A...

jdrurycisco · 03-22-2010

The L1/L2 ports are for clustering two 6100's together. Use a regular Cat5 cable to connect the L1 on switch1 to the L1 port on switch2 and do the same with the L2 ports. Then console to the first switch and run through the setup dialogue. If the ...

Member Since	‎10-13-2005 02:27 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	13

User Statistics

User Activity

SV1(2) to SV1(3) upgrade problem

Factory Reset?

Re: How to set RAID 1 in C200-M1

Re: UCS: Can't reach ESXi server

Re: UCS: Can't reach ESXi server

Re: L1 / L2 ports on 6100s