About Jesse3620

Jesse3620 · 05-25-2023

Hi Everyone, We currently have a CUCM cluster that consists of 4 IM&P Servers on 11.5. These servers are configured in two presence redundancy groups of two servers each in CUCM. Due to some external circumstances, we need to shut down the IM&P publi...

Jesse3620 · 02-17-2023

Hello, We need to configure additional NTP servers to our UCCX servers. I understand this is one of the parameters that will change the license mac on the server and force us to contact Cisco to rehome our license. Can anyone, that has done this befo...

Jesse3620 · 01-11-2023

Hi,We're going to be regenerating the self-signed certificates on our Call Managers that are currently configured as Session Managers.I've regenerated certs before on our actual CUCM environment by following this guide: https://www.cisco.com/c/en/us/...

Jesse3620 · 04-13-2022

Hi Everyone, I may just be overcautious, but I want to be extra careful when making changes on UCCX. My question is: can I update the Mail Server field under UCCX admin > Subsystems> eMail Configuration to a different fqdn while in production? We're...

Jesse3620 · 07-27-2021

Hi Everyone, We've been having a difficult time transitioning from POTS lines to SIP/ATAs for faxing in our environment. After much trial and error, we've finally settled on a configuration that results in T38 being negotiated over a SIP trunk via C...

Re: CUBE - SIP Profile Diversion Header · 07-13-2021

In case anyone comes across this in the future and wants to reference this, I finally found a config that works (for my use case). Essentially, I used both of your replies and created a sip profile paired it with a Sip copylist, where 'x.x.x.x' is th...

Re: CUBE - SIP Profile Diversion Header · 07-13-2021

Thanks for your responses. I'll try these out when I get the opportunity and report back.

Jesse3620 · 07-12-2021

"Its configured to so when you dial 99 but as soon as I do that a busy signal happen" - So you're using 99 as your access code for callers to reach the PSTN? This dial-peer is probably causing this issue then:dial-peer voice 123 potsdescription Outbo...

Jesse3620 · 07-09-2021

I wish I could offer more authoritative help but I'm just not that familiar with CME commands (although I'm sure we're in the right place for someone to contribute). One recommendation I have: double check the model and tftp files you have configured...

Jesse3620 · 07-09-2021

Do you have a DN configured on it? I'm not too familiar w/ CME, but I know for CUCM, you should have a DN configured before it registers properly.

Member Since	‎03-08-2020 11:35 AM
Date Last Visited	‎05-31-2023 12:02 AM
Posts	20
Total Helpful Votes Received	10

User Statistics

User Activity

IM&P Publisher planned shut down - consequences and expectations

Adding NTP servers to UCCX

Quick question about regenerating self-signed certs on CUCM (SME)

UCCX - Update eMail Configuration

SIP - ATA191 and T38 Fax Reliability and Performance

Re: CUBE - SIP Profile Diversion Header

Re: CUBE - SIP Profile Diversion Header

Re: Issue making a call through a POTS Line

Re: Voip registration issue

Re: Voip registration issue