Certain logs are not displayed properly in asa.We sent a particular udp packet 5 times.However, it is not seen in the asa log or only one is shown.What's the matter?
We are currently using asa.outside policysrc ip 192.168.1.0/24dst ip 192.168.100.10inside policysrc ip 192.168.100.10dst ip 192.168.1.0/24I set it up.With one connection, both the outside and inside hitcounts are rising.Is this correct?ex)192.168.1.1...
We have 1 asa product and fwsm product.
fwsm-asa
ㅣ
syslog server
It has this configuration.
While sending syslog from fwsm to syslog server, asa set the policy to block fwsm syslog.
But still fwsm is sending logs to syslog serve...
2950_A(config)#no service tcp-small-servers2950_A(config)#no service udp-small-servers2950_A(config)#no service finger2950_A(config)#no service pad2950_A(config)#no ip source-route2950_A(config)#no ip bootp server2950_A(config)#no ip domain-lookup295...
By connecting a hub to the 1815w port, 3 to 10 users communicate with one port. In this case, the ping falls out. 1815w Can not use many users in one port?
We have firewalls and server farm switches under the backbone.A udp packet was sent from the server farm switch to the client on the backbone side.But if you send 5 udp packets, you will see 1 or 2 if you are lucky.Doesn't look average I think not al...
If so, is there a problem with both the inside side and the outside side being hit count rising?As a result of checking the cisco document, it was confirmed that acl does not affect the sessions that are already connected.However, as a result of the ...
This is not what I want.It is possible, impossible, this is enough.For each item.I can't see it if I look for it over there.I want to know that it is possible and impossible, and if possible, I want to know the appropriate command.I'm not asking you ...
What I mean is this beacon.
https://www.cisco.com/c/en/us/td/docs/wireless/cmx_cloud/vBLE_HIG/b_ble2_hig/b_ble2_hig_chapter_01.html
Or ble beacon. We want to know where our equipment is moving.
Like gps
