About gregorypierce1

gregorypierce1 · 03-26-2020

IS there a way to upgrade the ios on a cisco 9200l switch using a usb drive instead of using a tftp server? If so could someone point me to the article or tell me how this can be done? These switches seem to be more complicated than previous switches...

gregorypierce1 · 02-01-2022

I wish I could find some setup instructions for these. The rath company shows how to change the IP but when iut comes to connecting it to your CM they say contact cisco. We just got two of these and I'm trying to figure out how to connect and registe...

gregorypierce1 · 12-18-2020

Got it figured out a while back, just forgot to update sorry. I was able to boot the switch using the drive and copy the file over at that point. Planning on going Meraki one day so I wont have to do this again.

gregorypierce1 · 03-26-2020

I should be able to copy as you said but it doesn't work as I said before. I've tried the copy mode mentioned from Rommon mode and from switch# mode as well with no working results as of yet. As far as the link goes, he set his up to boot from a tftp...

gregorypierce1 · 03-26-2020

After trying the commands with both usb ports I get the same result if I try to copy the file to flash. Flash is read only. switch: copy usbflash1:/cat9k_lite_iosxe.16.12.03.SPA.bin flash:Unsupported destination device/filesystem.

gregorypierce1 · 03-26-2020

switch: emergency-install usbflash0:/cat9k_lite_iosxe.16.12.03.SPA.binError: command 'emergency-install' not found. Use 'help' to list commands. That's all I get. Anyone else?

Member Since	‎03-26-2020 09:11 AM
Date Last Visited	‎07-06-2022 12:07 AM
Posts	6

User Statistics

User Activity

Cisco 9200L IOS upgrade via USB

Re: Third Party SIP Endpoint: Warning 399

Re: Cisco 9200L IOS upgrade via USB

Re: Cisco 9200L IOS upgrade via USB

Re: Cisco 9200L IOS upgrade via USB

Re: Warning: Bootable URL's in BOOT variable not found or exhausted message on Cisco 9200L