Hi All, Just wondering if anyone has been able to get a SPA500DS expansion module working with a SPA525G2 (or other SPA set) on a UC540? And if so, how did you do it?I've seen some older posts that Cisco had "support pending" for the SPA500DS on the ...
Hi All, Quick question - does the 'Cisco Agent Desktop' application automatically mark voice traffic with DSCP 46 and control traffic with DSCP 24/26? I know that Cisco IP Communicator marks this way - but I'm having trouble finding confirmation in C...
The user guide for the SPA 525G says that users can page/intercom to other users by using feature code *96 + the users extension. Any idea how this works? And how it is configured in the UC540? Its not working for me. I get fast busy after dialin...
Hi Everyone,I have a customer that upgraded from an old Nortel Norstar system to a UC540 - the staff used to listen to the music on hold source through their phone speakers on the Nortel sets, and they are want to do this on the UC540 with SPA phones...
Hi All,I have an analog phone on a FXS port - and I'd like it to be able to go offhook and make outbound calls without having to dial 9 first.This phone has no need to dial other extensions ... it just makes calls outbound to the PSTN.Outbound to PST...
Thanks George.Just a follow up question - If I understand CAD correctly, you can deploy it in 'hardphone' mode, where you would use a physical hardphone to create a nailed up or 'call by call' voice path - OR - you can deploy it in 'softphone' mode, ...
You should remove option 150 from your data dhcp pool ... option 150 should only be assigned to the phone dhcp pool - use command to remove:
ip dhcp pool data
no option 150 ip 192.168.10.1
Also, noticed that in your vlan configurations you have your ...
Could also be a physical issue with the cabling ... make sure the patch cables to the sets are good (swap them out with known good), and the cables from the patch panel to the jack have RJ45 terminations that follow the T568 B Standard ...
