About OscarPerez93198

OscarPerez93198 · 04-01-2020

Hi all, I hope you can help me. I have 2 switches SG350, and I want to propagate the VLANS I create in one of them to the other, I know that in this model there is no VTP domain to do that. I found out that there is a similar command that does that,...

OscarPerez93198 · 05-27-2020

Thank You, Apologies but I hadn´t come to the office until now, because of the contingency. Finally I had updated both switches to 2.5.0.92, but it did not work, no VLANs were propagated. about the option of disabling auto smart port, Should this be ...

OscarPerez93198 · 04-16-2020

Apologies for replaying late, but with the contingency I´ve been working in some other stuff, today I reboot both switch 2 but it did not work, the vlans created in switch 1 did not propagate. Do you know which is the last firmware for these switches...

OscarPerez93198 · 04-06-2020

Thanks again, I´ll do what you mention and back with the results regards

OscarPerez93198 · 04-03-2020

Thanks aturawat please correct me if I am wrong So this is what I should do in order to propagate the velans from the Switch 1 to siwtch 2,1.- Create all the vlans in switch 12.- Enable GVRP at global config in switch 13.- Enable GVRP in the port th...

OscarPerez93198 · 04-02-2020

Thanks aturawat, actually that is the way I configured the switches, GVRP is enabled in both interfaces, both ports are in trunk mode, and GVRP is enabled en global configuration, but ir is not working,this is the configurations in the ports of each ...

Member Since	‎04-01-2020 03:30 PM
Date Last Visited	‎08-12-2020 10:45 PM
Posts	6
Total Helpful Votes Received	5

User Statistics

User Activity

GVRP configuration between 2 SG350

Re: GVRP configuration between 2 SG350

Re: GVRP configuration between 2 SG350

Re: GVRP configuration between 2 SG350

Re: GVRP configuration between 2 SG350

Re: GVRP configuration between 2 SG350