Cabling between the 3750 and the N3048Ports 19 <-> 37: STRAIGHTPorts 20 <-> 38: CROSS-OVERLINK CONNECTED3750 port 19 ===> 3k port 37 speed 100 speed 100 duplex full duplex full no ...
PRIMARY RUNNING Config fetch failed for M1978NMS5-11 Cause: Couldnot enter ENABLE Mode from USER ModeI can putty into the device via SSH and have no problem with my credentials. I went to Common Services > Device and Credentials > Device Manageme...
I've got a Cat6 cross-over cable plugged between the two switches. With "Auto Negotiation" turned enabled the link comes up and auto establishes at 1000 FULL proving that the cross-over cable is capable of reaching 1gig speeds. If it was Auto establi...
The problem exists with both Cross and Straight.Using a straight cablespeed 1000, duplex full, negotiation auto Link is UP.speed 1000, duplex full, no negotiation auto Link is DOWN.
Using tacacs and this is for Internal users. I will create the user and check the box "change password on next login" I will then test that newly created user by trying to SSH into one of my cisco devices.(PUTTY)login as: bob.smithUsing keyboard-inte...
Your the man Joe.OpenedTacacsPrompts.iniAdded " username: and password: " after the following statements.USERNAME_PROMPT=username:PASSWORD_PROMPT=password:Deploy successful, Fetch successful.
Thanks for responding Joseph. I did what you suggested but I am still getting the same results, it appears that the TacacsPrompts.ini file is only listing Telnet for some reason. Do i need to add SSH into the file? Attached is what is currently runn...
