Hi,Does N9K-C93180YC-FX,N9K-C93108TC-FX, and N9K-C9348GC-FXP supports breakout 4x10G on QSFP ports?If not then what are the possible ways to 10G link working on those QSFP ports? Any suggestions?
HelloI am trying to install the certificate for vManage controller but getting the following errorFailed to retrieve device dataFailed to find device with uuid null I've tried the following methods to create a certificate but getting same error messa...
Hello We have setup the lab with 3 controllers (vManage,vBond & vSmart) installed on Vmware ESXI host. The controllers are behind firewall. therefore what are NAT requirements to allow communication between vEdge and Controllers. Do we need to NAT al...
Hi,
We are replacing our ASA's with Cisco FTD which includes AMP for Networks. We currently have a Bluecoat Prox y SG200 for forward proxy ? Do I need Kaspersky AV on bluecoat while I already have Cisco AMP.
Appreciating any suggestions
Hello,
We have a Catalyst 6509 ( WS-6509-E) with WS-SUP720-3B supervisor engine. I want to know if C6800-16P10G is supported on this chassis.
Could someone please able to help to confirm.
Thank you very much!
As per the compatability matrix, below are possible options to connect QSFP to 10G1. QSFP-40G-CSR4 with MPO connector cable can be used to breakout 40G QSFP port into 4x10G link2. CVR-QSFP-SFP10G adapter with SFP-10G-SR
HiI was able to successfully able to install the certificate with excellent support from Rohit Raj.He was very helpful on a remote session. Thanks Rohit Raj. I highly appreciate your time and efforts.
I simulating controllers behind NAT therefore I have added the public IP of vBond.Please let me know whenever you are available so I can send PM you the remote session details.
Hi Rohit we can continue the discussion here when specifically it is related here is lab details and vmanage configurationAlso I have attached the diagramFor certificate I followed the steps as you mentioned and also I used OpenSSL and XCA but experi...
Hihere is vmanage configurationAlso I have attached the diagramFor certificate I followed the steps as you mentioned and also I used OpenSSL and XCA but experienced same issue the lab is running on EVE-NG emulator system host-name vManage system-ip 1...
