Hi,Do any of the Jabber clients have the ability to display the full external number, like is shown ...

Thanks for confirming. I will just let the ECDSA certificate expire then.

Did you get a resolution? I was about to purchase another set of certs but I have a TAC engineer say...

Might be a little late, but I use #if($interfaceName.toString().contains("GigabitEthernet"))

Ah thanks for clarifying that for me. Hope you're able to solve your issue too.

Appears to be resolved. After this case was finally escalated, another engineer suggested to try cha...

Hi All, Just throwing this question out to the community as TAC have been less than helpful in resol...

Hi, I'm facing the same issue. Backing up using a Windows server such as Rebex works fine. Were you ...

Hi All, Looking for a comparison between these two models of switches, in particular the SG550XG-24T...

I don't think it's possible currently, can only do certificate auth on the router and then pass the ...

So I have it working - sort of...What is happening is the router is verifying the certificate, then ...

Thanks for your reply, but unfortunately those links don't quite apply to my case. The first is for ...

Hi,I would like to setup certificate based VPN authentication on a Cisco router but with the auth do...

Thank you both for your reply's. Yes the default vlan is the most used, so won't be perfectly load b...

Real easy one here... In the attached diagram, what would be the best way to load balance between th...