SPA9000 FW: 6.1.5 SPA400 FW: 1.1.2.2SPA921 FW: 5.1.8All devices are on the same LAN (private lan, only used for VOIP), no firewalls. Not using DHCP, all phone instruments have static IP's assigned (12 instruments). The SPA400 has a single ...
Can anyone provide the CLI commands to enable a SPA9XX series phone to register with the UC520. The SPA receives an IP address from the UC520 be never registers. Is it even possible to use the SPA phones with the UC520?
I am transitioning from a SPA9000 to a UC520. I am trying to still use my SPA VoIP phones, I realize I can't use the Cisco Configuration Assistant to set them up, back I can manually via browser or front panel. I don't see in the running config on...
I want to upgrade my current VoIP configuration of a SPA9000/SPA400 with a UC520-8U-4FXO-K9. I am using SPA921 phones, are they compatible with the UC520? How difficult is the setup for the UC520, the SPA9000 was very simple and easy to use.
I have a simple VoiP configuration using SPA9K, SPA400, SPA921 phones. I am trying to add a TEO TSG-6 phone into the configuration. The TSG-6 registers correctly however when I try to initiate a call to a local extension the receiving phone set nev...
If I understand correctly: The SPA921 phones can be used with the UC520 but I need to run SIP CME, but the Cisco Config Assist doesn't support that configuration. I would have to admininster the UC520 from the command line to set it up. Does that...
The attached zip file contains screen captures from the SPA9000. Yes, I agree that the problem is the ACK is not being forwarded by SPA9000, I have not found any setting on the SPA9000 that seems to affect/change the problem. The SPA921 works becau...
TSG6 settings as follows: SIP tab: Proxy id - 192.168.0.1 Proxy udp port - 6060 Registrar enable on Registrar id 192.168.0.1 Registrar port 6060 Registrar expiration 3600 seconds Backup proxy id Backup proxy port 5060 Backup registrar enable off Back...