Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- :
- About mike.murrin82
Stats
Member since
09-23-2010
4
Posts
0
Helpful
0
Solutions
10-22-2010
08:56 AM
Unfortuanety the office is open now and I can put them into SRTS mode to do further debugging at this time. Does the config look right for the most part?
... View more
10-22-2010
08:20 AM
Here is the full config voice translation-rule 1 rule 1 /^86535297\(..\)$/ /76\1/ rule 2 /^865682....$/ /917172708412/ rule 3 /^86534344..$/ /917172708412/ rule 4 /^8653454442$/ /917179710027/ voice translation-rule 2 rule 1 // /86535297/ voice translation-profile toBUFforSRST translate called 1 voice translation-profile ADD_AREA_OUT translate calling 2 voice-port 0/0/0:23 translation-profile outgoing ADD_AREA_OUT dial-peer voice 20 pots destination-pattern 9[2-9]...... port 0/0/0:23 forward-digits 7 ! dial-peer voice 21 pots destination-pattern 91[2-9]..[2-9]...... port 0/0/0:23 forward-digits 11 ! dial-peer voice 911 pots destination-pattern 911 port 0/0/0:23 forward-digits 3 ! dial-peer voice 9911 pots destination-pattern 9911 port 0/0/0:23 forward-digits 3 ! dial-peer voice 1 pots translation-profile incoming toBUFforSRST incoming called-number . direct-inward-dial port 0/0/0:23 ! dial-peer voice 10 pots destination-pattern 4... port 0/0/0:23 forward-digits all prefix 91717961 ! d call-manager-fallback secondary-dialtone 9 max-conferences 8 gain -6 transfer-system full-consult timeouts interdigit 5 timeouts busy 30 timeouts ringing 60 ip source-address 172.25.15.254 port 2000 max-ephones 25 max-dn 100 dual-line system message primary Your System is Jacked system message secondary FallBack
... View more
10-22-2010
07:49 AM
I am trying to get SRST working. So far inbound calling works fine but I cannot get any outbound calls to work out the PRI. Hear is a sample of my dial peers: dial-peer voice 20 pots destination-pattern 9[2-9]...... port 0/0/0:23 forward-digits 7 ! dial-peer voice 21 pots destination-pattern 91[2-9]..[2-9]...... port 0/0/0:23 forward-digits 11
... View more
Labels:
09-23-2010
05:24 AM
I am trying to build a DMVPN as a backup for our MPLS WAN. The MPLS network is using BGP for its routing protocal and I would also like to use BGP on the DMVPN. The routers in each branch will have a DSL connection on its second ethernet interface. I have a separate 2811 router in the home office that will handle the DMVPN. My question is how can up update the BGP table for all the sites to see the second route through the DMVPN if the MPLS goes down? Should I put static routes into the table using a higher wieght for the DMVPN routes?
... View more
Labels:
10-22-2010
Unfortuanety the office is open now and I can put them into SRTS mode to
do further debugging at thi...
10-22-2010
Here is the full configvoice translation-rule 1 rule 1
/^86535297\(..\)$/ /76\1/ rule 2 /^865682.......
10-22-2010
I am trying to get SRST working. So far inbound calling works fine but I
cannot get any outbound cal...
Public Statistics
| Date Registered | 09-23-2010 05:11 AM |
| Date Last Visited | 08-18-2017 03:53 AM |
| Total Messages Posted | 4 |
