hi all
quick qos question,
if I have with the command bandwidth, class A 30%, class B 30% and class C 20%, the default will have 20% right?
the question is, the default class can take up to the 100% of the BW if the other classes are not using it?
...
Hi experts,
I just received a document with this vulnerability: "SSH Server CBC Mode Ciphers Enabled" for many cisco switches.
the description says:
"The SSH server is configured to support Cipher Block Chaining (CBC) encryption. This may allow an...
Hi experts,
I just received a document with this vulnerability: "SSH Server CBC Mode Ciphers Enabled" for many cisco switches.
the description says:
"The SSH server is configured to support Cipher Block Chaining (CBC) encryption. This may allow an...
Hi Experts, I would like to know if the CEF process on a router is done by an ASIC circuit? I mean by hardware at the same way than in a switch? or that's done by the CPU of the router?Thanks in advance!
Hi experts,I have a question, how can we perform a load sharing between BGP and IGP?Lets say that we have a WAN link connected to the MPLS with BGP in siteA, and in the same way we have siteB (we a MPLS link). Apart of that we have a Point2Point link...
Hi Mario, thanks for respond. Please find attached a topology that just did in GNS3,Site A learns route 3.3.3.3 (for example) from site B via BGP (MPLS link) and also the same via EIGRP (Point2Point link between them).I hope this can clarify my quest...
