Hello, I have set up a lab on Cisco Modeling Lab and having problem configuring IP on the desktop. I did the ifconfig x.x.x.x mask x.x.x.x but getting error
Hello, I recently bought a ucs c220, installed server 2016, the ip address for the remote access is in the same network as with other computers. The problem is when I launch the kvm i get the following error. please see attached. Im using java vers...
Hello, I'm using WLC 2504 with one access point and and spectrum cable modem. The AP and WLC are connected to a switch, the switch is connected to the spectrum cable which is used for DHCP. The AP is getting an IP but not joining the WLC. I'm only ...
I'm studying for my CCNP so I bought this WLC 2504 but it seems not to have Service interface configuration only the management interface. My understanding the management interface is used for the capwap. What type of interface should I configure ...
I’m not in front of my computer so I don’t have the error. I entered the following commandifconfig eth1 192.168.0.1 mask 255.255.255.0 i pressed enter and get an error. Its a virtual desktop on Cisco modeling lab. I think i
I figured out, I needed to tag the management int to a vlan and configure a trunk port from the switch. One question i have now is this: it says on licenses:base is permanent bass-ap-count type evaluation 75 days. does anyone know?
