About VK20

VK20 · 03-08-2021

I have a n9k switch where I have couple of vrf's like management,default,107,108 . Traffic is getting routed via management.I want to make 107 vrf accessible to outside network.I have very limited commands in management so can't leak routes.

VK20 · 02-16-2021

Hello,In a lab setup, I want to set up 2 bgp instances in 2 vrfs to test eBGP feature among those 2 instances.I have one n9k is this possible to set up.How would I leak routes between 2 vrfs? Is it possible to have 2 AS numbers on the same n9k or do ...

VK20 · 06-01-2020

Its a ws-c3850-48tMy member 4 and 3 are stuck at syncing after power outage. Why is the config not syncing?Tried reloading and unplugging the cables.Should I remove the stack member ? Then plug the cable back in?Something like: https://vmguru.com/201...

VK20 · 05-14-2020

Hello,I need recommendations for core switch.Should support ipv6, 96 1g ports, a good mac address table size?I currently use 3850 and we are going from 5 racks to 18 racks so I need better core switch. I don't have a huge budget but $20k or something...

VK20 · 03-05-2021

Hello,If I may ask for a followup question.I want to make router id of vrf 107 accessible to networks outside switch. Is this possible ? As any interface I try to configure with the vrf it has to be in routed mode and its not reachable outside. I tri...

VK20 · 02-22-2021

I was able to set up following your advice.BGP neighbor is ipA, remote AS 65001, ebgp link, Peer index 3BGP version 4, remote router ID ipBNeighbor previous state = OpenConfirmBGP state = Established, up for 00:01:56Neighbor vrf: 107 Thank you so mu...

VK20 · 02-20-2021

I am sorry active command is not there under bgp/vrf/address familyAlso I changed the config a little to see if it changes anything.I have made ipA and ipB in a different subnet. I do have connectivity between themThe message has changed a little BGP...

VK20 · 02-19-2021

Thank you for your response.I did change the mac address they were the same. But still eBGP won't peer, Gives the same error. I have connectivity among the vrfs. vrf context 107rd 65000:100address-family ipv4 unicastroute-target import 65000:300rout...

VK20 · 02-19-2021

Some more followup.I am unable to establish eBGP session with peer it stays in an ideal state.# sh ip bgp vrf 108 neighborsBGP neighbor is (ipB), remote AS 65000, ebgp link, Peer index 3BGP version 4, remote router ID 0.0.0.0Neighbor previous state =...

Member Since	‎05-14-2020 12:32 AM
Date Last Visited	‎03-19-2021 12:01 AM
Posts	16
Total Helpful Votes Received	20

User Statistics

User Activity

n9k switch/vrf not able to talk to outside

Multiple BGP instances on n9k

Cisco 3850 stack member 1 current state stuck on syncing and stack member 2 stuck at sync not started.

Recommendations for core switch

Re: Multiple BGP instances on n9k

Re: Multiple BGP instances on n9k

Re: Multiple BGP instances on n9k

Re: Multiple BGP instances on n9k

Re: Multiple BGP instances on n9k