About StevenPhipps35347

StevenPhipps35347 · 01-20-2022

Hello, I've been looking for the 5525-X end or life/end of sale and not found consistent results. The cisco.com page indicates it is available. There is a link for the EOL, but it fails with an error. I need to know the true EoL, EoS, and end of s...

StevenPhipps35347 · 01-12-2022

Hello, I'm working with a customer who has a pair of Nexus 9300 for a core switch. They have configured interface mgmt0 as vrf member management, and applied an IPv4 address. They have recently added Meraki MX to the environment to service their ...

StevenPhipps35347 · 08-30-2021

I've been asked to configure an ASA 9.x routed mode with two DMZs. An APP server currently sitting on the internet with two outside interfaces, and one inside interface should span (bridge) these two DMZs Inside on on DMZ, outside on another. The cur...

StevenPhipps35347 · 08-03-2021

Hello, I need to configure an ASA 5545 as a pass-through filter for devices (two, with one inside, and two outside interfaces each) that are connected directly to the internet. They do not want to use Firepower. I have configured one-to one NATs f...

StevenPhipps35347 · 07-14-2021

Hello, I'm working with a network I inherited. They have two WAN providers; one has one eigrp assigned internally, the second has two assigned internally. The Data center cores are configured with five different instances (#) of eigrp, and an ospf...

StevenPhipps35347 · 01-13-2022

Seb, Thank you so much. This will help make my case. Steve

StevenPhipps35347 · 01-12-2022

Seb, Thanks for the reply. Am I to understand that the value of 250 then makes that route least favorite over the zero value found in the mgmt0 interface? I'm hoping to discourage using the same subnet as a management vrf and a production VLA...

StevenPhipps35347 · 08-04-2021

I have been experimenting with transparent mode. I have a lab setup which I've been able to apply an ACL to filter the requested ports from hosts on the inside network to the gateway outside. I wonder if this might be the way to go? I applied the sam...

StevenPhipps35347 · 08-03-2021

Hello, Thanks for the reply. The setup they have now just connects all the device outside interfaces to individual ports on a cable modem. They would prefer not to use an additional switch, hence the BVI(s). I've used that to basically create a sw...

StevenPhipps35347 · 08-03-2021

hello, Sorry I let this thread go so long. For their internal network (not partners) there are 10 different OSPF AS #, and 7 different EIGRP AS # for nine sites. Two sites have the same OSPF #, and two sites have two different OSPF #. All of these...

Member Since	‎05-15-2020 06:16 AM
Date Last Visited	‎01-20-2022 04:14 PM
Posts	11
Total Helpful Votes Received	5

User Statistics

User Activity

What is the true EOL/EOS for the Cisco 5525-X

Nexus 9300 IP subnet defined on management vrf and local VLAN

Server bridging two DMZ

Configure ASA 5545x to allow/filter specific traffic in and out

How many iterations of eigrp and or ospf are too many

Re: Nexus 9300 IP subnet defined on management vrf and local VLAN

Re: Nexus 9300 IP subnet defined on management vrf and local VLAN

Re: Configure ASA 5545x to allow/filter specific traffic in and out

Re: Configure ASA 5545x to allow/filter specific traffic in and out

Re: How many iterations of eigrp and or ospf are too many