Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, I have a Cisco C867VAE I'm trying to use with Superloop (Australia) VDSL2 IPoE. The first thing I did is update the IOS to the latest (c860vae-ipbasek9-mz.154-3.M10.bin). I then set up the VDSL only without doing anything else to test that it...
Hi all, I'm trying to setup FastEthernet0 and assigning it an IP Address for the sole purpose of upgrading the firmware using that switch port. I've tried to do this using a VLAN and assigning it to FastEthernet0. On the computer I have a direct cat6...
Hi Georg, No I don't but I hassle them into giving me the latest firmware which didn't work (from here: https://www.cisco.com/c/en/us/support/routers/c867vae-integrated-services-router-isr/model.html#~tab-downloads). This is why I suspect it is an 86...
I updated to c860vae-ipbasek9-mz.154-3.M10 which is the latest firmware that worked. c860vae2 firmware from here https://software.cisco.com/download/home/286309142/type/280805680/release/15.9.3M1?i=!pp sent it into a rommon loop. I'll try to just upd...
Hi Chris, It's been about a hundred years since I did my CCNA. I used to be an IT Consultant by I'm the CEO of a big company now so don't get a chance to keep up and I'm typing this after work with a baby on my lap. Basic commands still seem the same...
Hi Paul, Thanks for that. operating mode auto produced the same result (dropping in and out). sh controller vdsl 0 Controller VDSL 0 is DOWNDaemon Status: NAXTU-R (DS) XTU-C (US)Chip Vendor ID: 'BDCM' 'BDCM'Chip Vendor Specific: 0x0000 0xB1BFChip Ve...
Hi Georg, Thanks for that. If I have 'no wan mode dsl', it defaults to 'wan mod eth' (they seem to be the only two options) and it shuts down E0. I don't understand why but on other VDSL configs I've seen they have 'wan mode dsl'.
