Dear all,I'm using a SG300-52 with firmware 1.4.11.4 and Ubiquiti SFP Multinode 1G modules. This configuration was now working for the last 2.5 years. Yesterday for what ever reason the SG300 keeps booting all over again. After I found a PC with a se...
I just wanted to pull the trigger of 3 CBS switches but then found this thread. Does anybody know what the reason for this "misalignment" was? Any info about if Cisco is changing it? If not I need to look somewhere else for switches.
Could this config be the problem. I would guess so. TBH I don't know why it shows "speed 10". In the GUI it's set to Auto-negotiation. interface Port-channel1speed 10description Uplink-Ubiquitiswitchport trunk allowed vlan add 10,20,40-41,70,90,100,1...
Just for information. I encountered this issue also on a B200M5 with 3.2(3j).The issue is also depending on the Board Controller Firmware.In my case I have 2 versions. v11 and v12. The reason for that is that 3.2(3j) is released with v11 but newer UC...
