About Zed969

Zed969 · 06-21-2020

Apologies for the long title. This firmware update *just* came out. Usually I wouldn't brave it this soon. But my circumstances are this: I have used gear arriving that I've acquired for a lab setup for a couple of related projects and I have qty 2, ...

Zed969 · 07-13-2020

I hear you. You can use the CLI commands with SSH as well. I've neverconsole'd into my SG350-10P actually. SSH works well remotely, and sinceit's built-in to most OSes you can just start a session from CMD.exe inWindows & from the bash shell on Linux...

Zed969 · 07-12-2020

That is the painful way around! But hey, it's like all that pre-Calcalgebra to do 'caclulus' then they teach you the derivative. Facepalm! Iknew it shouldn't be this hard.So, figuring it out no matter the method has value. Then you can find & usethe ...

Zed969 · 07-12-2020

Something like this:interface vlan 1ip address 192.168.xxx.xxx 255.255.255.0no ip address dhcp

Zed969 · 06-29-2020

Yep. Looks like you have all the various energy saving things on &available. Looks like the switch is choosing how to apply it to each portincluding by cable length.I'd suggest backing up your current config and just for diagnostics,turning all of it...

Zed969 · 06-29-2020

You're not kidding! From a quick glance, its all over the place. I got abounce notification for my last reply, but I sent the output of mygreen-ethernet and EEE settings as well as the output of 'show powerinline output' or whatever that command was ...

Member Since	‎06-07-2020 02:41 AM
Date Last Visited	‎07-29-2020 12:06 AM
Posts	19
Total Helpful Votes Received	5

User Statistics

User Activity

Software Version 1.4.11.5 rn Page 7 says there exist 2 HW revs: HW VID=01 & 02. My SG300-10 reports HW VID=04. ????

Re: Configuring a new SG350-10 Switch

Re: Configuring a new SG350-10 Switch

Re: Configuring a new SG350-10 Switch

Re: SG500-52p PoE Voltage fluctuating

Re: SG500-52p PoE Voltage fluctuating