About MSDelamater

MSDelamater · 05-25-2022

Having an problems passing dhcp traffic between Unifi APs and 1121-4p router. Physical layout is:1121-4 Router --> SG200 switch -->TLS circuit --> UAP-AC-SHDWhen the APs are using default vlan, clients and APs receive dhcp addresses. 10.20.30.x Wh...

MSDelamater · 03-09-2022

Hello, Cannot find what is missing to allow devices attached to VLAN1 to access the internet. Laptop gets dhcp address, can ping 192.168.20.1 and interface gi0/0/1 which gets it address via dhcp. Laptop cannot ping 8.8.8.8. It has received an ip o...

MSDelamater · 06-10-2020

Hello,Upgraded from a 1841 router to a ISR4221/K9. Previous router used: ip nat inside source static tcp 10.0.10.3 443 X.X.X.3 443 extendableTrying to modify the command for 4221. X.X.X.3 is a public ip addressX-VPN#config-tadmin connected from 1...

MSDelamater · 05-26-2022

Switched the clients to use VLAN30 and they got 10.20.30.x addresses. It is now working as intended, Thanks.

MSDelamater · 05-25-2022

Before creating the vlan10 and its dhcp setting, I had tried setting interface GigabitEthernet0/1/1, switchport mode trunk. Deleted the switchport-access setting. Current config. interface GigabitEthernet0/1/1switchport trunk native vlan 10switchpor...

MSDelamater · 05-25-2022

Since the C1121-4P has both a switch and router built in. It causes a bit of confusion on my part. Presently Gi0/1/0 is set to :interface GigabitEthernet0/1/0switchport access vlan 30 I have tried connecting the SG200 to Gi0/1/1 in trunk mode but...

MSDelamater · 03-11-2022

Connected the laptop via Wi-Fi and it had internet connectivity so that lead to searching about phones connecting to Wi-Fi not seeing the internet. The solution was to change the DNS server in the DHCP config to 8.8.8.8 8.8.4.4 192.168.20.1. Thi...

MSDelamater · 03-10-2022

Earlier I had created a VLAN100 before deciding to start over. Rather than do a factory reset, I deleted startup-config from the router. Could not find any reference in today's log entries related to the phone. Did not find any reference to VLAN100 ...

Member Since	‎06-10-2020 03:30 PM
Date Last Visited	‎05-27-2022 12:05 AM
Posts	13
Total Helpful Votes Received	10

User Statistics

User Activity

When Tagged AP clients not receiving dhcp address

C1121-4P Vlan not routing to internet.

Cisco IOS XE , ip nat inside source static IP4 Port

Re: When Tagged AP clients not receiving dhcp address

Re: When Tagged AP clients not receiving dhcp address

Re: When Tagged AP clients not receiving dhcp address

Re: C1121-4P Vlan not routing to internet.

Re: C1121-4P Vlan not routing to internet.