About rebazsalih

rebazsalih · 03-02-2021

Dears I have allowed to access a websever on HTTPS port onlythe problem is when a client tries to access HTTPS , firepower will allow client to access webserver and in event viewer will show ClientIP:sourceport to WebServer:443 allowed but the prob...

rebazsalih · 03-02-2021

Hello Dears Why does some traffic is blocked in firepower for example from 2.2.2.2:3344 to 10.1.1.10:443 is allowed while response back from 10.1.1.10:443 to 2.2.2.2:3344 I only allowed traffic from public (2.2.2.2) to reach 10.1.1.10 on port 443 ...

rebazsalih · 09-10-2020

Hello I want to implement Duo integration with your Cisco Firepower Threat Defense (FTD) SSL VPN to add two-factor authentication to AnyConnect VPN logins.without using ISEThis Link ( https://duo.com/docs/cisco-firepower ) describs steps on how to d...

rebazsalih · 09-09-2020

Hello is there any way to change Bandwith or traffic units in Kbps to Mbps in cisco firepowerbecause all widgets in the dashboard dispalys data in Kb not in Mb

rebazsalih · 09-07-2020

Dears I have firepower and I configured site to site vpn between ,protected network in site A is 10.2.3.4 and in side B is 172.15.3.4, I added tow Access rule policyes to reah each other,when I ping from Site A to Site B,I can see in Analysis-Events ...

rebazsalih · 01-21-2024

Hi IvanPlease follow below documentationDuo Two-Factor Authentication for Cisco Firepower Threat Defense (FTD) VPN with AnyConnect | Duo Security

rebazsalih · 03-03-2021

Hello Balaji The webserver is located in DMZ in our Network(a Public IP is NATTed to the Webserver IP), when some one tries to reach it from Outside (Public) this issue will occur

rebazsalih · 09-11-2020

Can you please share authproxy config file please, Or did you take any other steps rather than what is mentioned in the documentation. When adding RADIUS aerver in ftd, which one did yoi choos, base on routed or specific interface?

rebazsalih · 09-10-2020

Thanks Rob for reply, did you configured duo with FTD? I have a concern that it can not be done without ISE. As I mentioned, I did exactly what is done in the documentation, and I checked the authproxy file authproxy_connectivity_tool.exe, all serv...

rebazsalih · 08-27-2020

Hello Rob, No, Site B and C don't have a direct VPN connection, I want to route between them via My site and For your information I use Firepower to do the route between Site C and B

Member Since	‎06-24-2020 10:50 AM
Date Last Visited	‎01-31-2024 12:13 AM
Posts	21

User Statistics

User Activity

Response Traffic is blocked by Firepower

Firepower blocks response data from initiator IP

Intigration Duo with Cisco Firepower Threat Defense (FTD) VPN with AnyConnect

How to change memeasurement unit in cisco firepower (FMC)

I cant see traffic in Connections->Events

Re: Intigration Duo with Cisco Firepower Threat Defense (FTD) VPN with

Re: Response Traffic is blocked by Firepower

Re: Cisco Firepower Threat Defense (FTD) VPN with AnyConnect

Re: Cisco Firepower Threat Defense (FTD) VPN with AnyConnect

Re: VPN Site to Site Connection