Hi Julio,Here's the output from both show ip nat translations and debug ip nat. The following output...

Hi JulioThank for the prompt reply. It is indeed a typo. It should be:ip nat inside source list NAT_...

Hi Community, I'm trying to setup NAT for the following scenario with no success so far. I need mach...

for the record: after applying the 5.5.0 build-3116895 patch the problem with the VM automatic start...

Hi Ayodeji, Thanks for your input on that. Already took it into consideration after applying the upg...

Hi Rajan, Actually, that's one of the discussions I read previously. The problem is that the recomme...

Hi, The Scenario I am deploying a Unified Communications solution based on a Cisco BE6000 environmen...

Hi,I'm trying to upgrade a CUCM running version 10.0.0.97026-19 into version 10.5.1.10000-7 but, app...

Hi Leo,Thanks for the link. I'll forward it to the client. It might be helpful.regards,

Hi,A client has 2x2811 acting as Voice Gateway and backup Voice Gateway and both, after some undiscl...

It is confirmed. It was related to the certificates.with help from this good doc http://www.cisco.co...

After some more digging I think the problem might be related to certificates between PUB and the SUB...

Hi,Cluster (1 PUB + 4 SUBs) running on VM with version 8.6.2.20000-2 VMware Installation: 2 vCPU Int...

Hi,I have a cluster (PUB + SUB) running 8.6.2.20000-2 version.EM phone service is pointing towards s...

Hi,The scenario:CME 7.1 with 15.0.1M9 IOS versionPHONE A gets CALL 1, transfers (with the intent to ...