About andyspranata

andyspranata · 02-03-2012

Cisco 891 configuration Details:version 15.0no service padservice tcp-keepalives-inservice tcp-keepalives-outservice timestamps debug datetime msec localtime show-timezoneservice timestamps log datetime msec localtime show-timezoneservice password-en...

andyspranata · 01-29-2012

I would like to configure cisco 891 behind an ADSL Router(ISP one).The Details are:ADSL Router:- DSL Connection: dynamic IP- LAN: 10.153.66.1/255.255.255.128CISCO 891- WAN: 10.153.66.5/255.255.255.128- LAN: 10.153.64.1/255.255.255.128 - Configuration...

andyspranata · 02-04-2012

Hello Thotsaphon Lueangwattanaphong,You are a genius.I should take the CCNA course soon to become like you.Thank you very much.Andy

andyspranata · 02-03-2012

Hi, I have test it - and it is working.So the FastEthernet8 will not active when GigabitEthernert0 is active.is there a way to make sure that both of them active but GigabitEthernert0 as the primary.because I would like to configure 1 ip - 10.153.64...

andyspranata · 02-03-2012

Thanks Man,You are correct - I just tried it and it is workingThe failover configurationThanks to you.Best regards,Andy

andyspranata · 02-03-2012

Please find below the ping details #pingProtocol [ip]:Target IP address: 8.8.8.8Repeat count [5]:Datagram size [100]:Timeout in seconds [2]:Extended commands [n]: ySource address or interface: FastEthernet8Type of service [0]:Set DF bit in IP header?...

andyspranata · 02-03-2012

HI ,It was a wrong copy-paste configuration: the right one is:ip nat inside source route-map A interface FastEthernet8 overloadip nat inside source route-map B interface GigabitEthernet0 overloadroute-map B permit 10match ip address 110match interfac...

Member Since	‎01-29-2012 06:05 PM
Date Last Visited	‎10-09-2017 01:20 PM
Posts	12

User Statistics

User Activity

Cisco 891 Fail over Configuration

Cisco 891 behind ADSL router

Re: Cisco 891 Fail over Configuration

Re: Cisco 891 Fail over Configuration

Re: Cisco 891 Fail over Configuration

Re: Cisco 891 Fail over Configuration

Re: Cisco 891 Fail over Configuration