Hello,I am trying, in my lab, to make computers running in a private vlan, reach the gateway. I am probably missing some config on the trunk port, I believe. The lab looks like this - see attached picture So, the PCs running behind sw01 and sw03 are ...

HelloI have the following setup in my lab - see configuration further down.The issue is that I do not get response on NAT The idea is to import routes from several VRFs into one common VRF to provide internet connectivity. Doing a debug on the router...

Hello. I am trying to set up al lab with route reflector and vrf-s. I have managed to set up the route reflectors and clients. All looks fine. Routes are being propagated.  The issue is that from DMZ router, using the interface assigned to vrf 14000_...

Hello I may lab I am trying to configure router Loc1Office1 to export only LAN 10.1.0.0/24 to route target RT 65000:100 (this is route target for shared services) However, using my config, it looks like all LANs are exported into this RT, not only th...