I have tunnels on a cisco router 4221but i wanted traffic from 1 tunnel to be Natted and leave the rest,.i used a route map on a static NAT. but when i enable the route map on the ip nat other tunnels pass traffic through very well, but refuses on th...
I have a router at Main Office of model: Cisco IOS Software, C1900 Software (C1900-UNIVERSALK9-M), Version 15.2(4)M5, RELEASE SOFTWARE (fc2) which i am trying to create a VPN to a remote site with the following verison" Cisco IOS XE Software, Versio...
Hey Rob, 1. The correct peer is defined in the crypto map for the remote site.2. I don't have any ACL permitting UDP/500, ESP (UDP/4500 if nat) directly on both routers. 3. At the remote site there is no device after the router. Thank You
Yes we have ACLs on the main office router.Currently the remote router cannot access the main office, the only interface it can ping is the public ip of the main office. I have run a debug on the main office router but here is no sign of that specifi...
Hello Rob, My Main Office router has over 25 remote offices connected and able to communicate to main office. The topology is like this at the main office. Router (1921 series) >>>> Firewall >>> Internal LAN On the remote router (4200 Series) th...
