May I know which ports should I allow for my access list to allow my group policy objects to pass through my core switch which is a layer 3 switch. Here's a sample of the ports I used permit udp any eq bootpc any eq bootpspermit icmp 10.10.20.0 0.0.0...

Hi all, I can't seem to find a way to allow my GPO to pass through my core router(which has ACL running). I was able to determine that the cause of this was the packets were being blocked by the ACL because if I remove the ACL on the VLAN, the GPO ta...

Hi all, I can't seem to find a way to allow my GPO to pass through my core router(which has ACL running). I was able to determine that the cause of this was the packets were being blocked by the ACL because if I remove the ACL on the VLAN, the GPO ta...