Can someone assist me.I have created a bootable USB with ncs540-usb_boot-7.x.x.zip. I moved the zip file to the USB and extracted the ZIP file and moved boot & EFI folders to the root of the USB I insert to the router, power it on, break the boot by ...

We are trying to upgrade a NCS-5501 to 7.3.1 but it keeps failing saying not enough space but doing a show media shows that there is plenty of space in harddisk:  Any suggestions?ov 14 13:54:27 Install operation 11 started by Cisco:install activate i...

We just got a C9300-48UN-E for our lab.  Not familiar with 9300s.   There is C9300-NM-8X module but on show ip int brief the NM slot is displaying all of these portsGigabitEthernet1/1/1 unassigned YES unset down downGigabitEthernet1/1/2 unassigned YE...

We have an ASR1002-HX and we are trying to boot off usb0:  Whenever we break boot and go to rommon and issue a dir usb0: or dir bootflash: we keep getting this messagePlease reset before bootingWe issue reset and try again to no avail and it keeps ge...

We have a ASR920-12SZ-IM that was running IOSXE 15.6.2 perfectly fine.  Upgraded unit to 16.5 and it upgraded the FPGA automatically.  Then it rebooted, then we noticed that after it reboots, it keeps stating that FPGA needs to be upgraded and goes i...