About Amine M.

Amine M. · 01-25-2017

Hello As I am preparing a CCNA Security, I would like to buy a used ASA on eBay. There are some between £100 and £200 with some VPN licenses. One of my concerns, is the licensing. I don't want to buy something that would be essentially a brick beca...

Amine M. · 01-13-2017

Hello The other days I did a Webex to help a customer to configure some vlans and add them to existing trunks. Something surprised be but I didn't want to ask the customer. In my lab equipment, if I am on the global config mode or under an interfac...

Amine M. · 01-11-2017

Hello guys, This is my first post here. I created a multi-area OSPF topology with one particular area at the edge which I defined as "stub". The stub router received a default route pointing to its neighbour but still its routing table showed all O...

Amine M. · 01-16-2017

Here is the output from my Router and you see it has vlans: Main#sh ip int brInterface IP-Address OK? Method Status ProtocolFastEthernet0/0 192.168.100.254 YES NVRAM up downFastEthernet0/1 unassigned YES NVRAM administratively down downSerial0/2/0 u...

Amine M. · 01-16-2017

Hello Yes, it's possible to have vlans on a router. I have a router with a 4-ports L2 card (Cisco HWIC-4ESW). These ports are pure L2 ports. I can't assign IPs to them. If I go under the interface and I issue "no switchport", it's not accepted. Howev...

Amine M. · 01-13-2017

Thank you Mark!!! Noted. The do not necessary on any platform running nx-os

Amine M. · 01-11-2017

Yes, it helps a lot :) I am preparing the CCNP Route. I I have been working on the OSPF 3 weeks solid.

Amine M. · 01-11-2017

Thank you! Yes, my area was totally stubby. I would have almost gotten away with a 0.0.0.0/0 route towards the single ABR but I needed to advertise connected networks. I am going to read the document your shared.

Member Since	‎01-10-2017 05:42 AM
Date Last Visited	‎09-26-2018 03:43 AM
Posts	11

User Statistics

User Activity

Buying a used ASA

"do" in global config mode

OSPF Stub without no-autosummary

Here is the output from my

Hello

Thank you Mark!!!

Yes, it helps a lot :)

Thank you! Yes, my area was