@Georg Pauwen @balaji.bandi @Giuseppe Larosa @Leo Laohoo @Richard Burts @Rob Ingram @Marius Gunnerud @Aref Alsouqi @Marvin Rhoads Hello Guys I got two PE sites in MPLS connectivity working great, i added third site and able to form bgp neig...
Hello Experts @Richard Burts @balaji.bandi @Marius Gunnerud @Rob Ingram @Marvin Rhoads @Giuseppe Larosa @Aref Alsouqi @Mohammed al Baqari I am looking for options for 2nd factor authentication on Cisco ASA Any Connect VPN Connectivity? Plea...
Hello Experts @Georg Pauwen @balaji.bandi @paul driver @Richard Burts @MHM Cisco World I have two sites where underlying ospf is configured and then BGP is configured. Site A is advertising 189.75.62.x/24 to BGP and Site B is advertising 189.75...
Hello @Giuseppe Larosa @MHM Cisco World @Richard Burts The issue got fixed and yes only ME3600 side was not receiving any route. I just made the intial change request that was requested by @Richard Burts but it does not make any difference. The ...
Hello @MHM Cisco World Switch does not allow no auto-summary command in bgo vrf config, If you checked other two switches are without it as well so that should not be problem Thanks
Hello @Giuseppe Larosa @Richard Burts @MHM Cisco World I changed Subnet mask of loop0 and clear ip bgp * all on ME3600-LHIT but same issue, its not learning any routes. Thanks
I am posting #sh ip bgp all from all three routers. If you see XC-1 and XC-2 are learning loop1 (10.200.255.255) in vrf LHIT-internal from R3 but R3 is learning no routes in that vrf. Right now #ME3600-LHIT is not advertising anything else than lo...
Hello @Rob Ingram @balaji.bandi I did the change. access-list inside_access_in extended deny ip host 10.170.150.188 any And it blocked the outside access but it also block intra subnet access (like from 10.170.150.88 to 10.170.150.23 ). My motive i...