Hello team,SNMP is configured in ACI and the SNMP manager is NNMi, when traps are sent from APIC for interface down, the message is not readable, for example, the format below:"cieLinkDown1.3.6.1.2.1.2.2.1.1. = ,.1.3.6.1.2.1.2.2.1.7. =1,.1.3.6.1.2.1...
Hello Team, I'm trying to configure Microsegmentation for physical Domain EPG (IP attribute, which is supported according to doc), but, it's not working as expected. note: leaf is 2nd gen (-EX model)Any idea, please.Thanks
Hello Team,I have a consumer EPG in the common Tenant and other provider EPGs in user Tenants. when applying service graph PBR between them should i configure the service graph in Common (where consumer reside) or in the User Tenant.I checked documen...
Hello Team,I'm configuring EPG with VMM Domain association to AVE Domain with the native mode selected.The port-group is pushed to vcenter VDS with a Vlan taken from the Vlan Pool (Dynamic, external block) but the VLAN is not added to active VLANs un...
Hello Team, We are configuring dot1x on ASR1001-x, the configuration is detailed below: Router(config)# dot1x system-auth-control
Router(config)# aaa new-model
Router(config)# aaa authentication dot1x default group radius
Router(config)# interface G...
Hi, - it's L3 BD, gateway resides in ACI (unicast routing enabled).- Yes, the endpoint is detected in the base EPG.- No faults generated in base or uEPG.- No, even when selecting the MAC attribute and putting a MAC of a learned endpoint, it doesn't m...
Hello Sergiu, Thanks for your reply, I mean it's not working at all. The endpoint isn't classified according to attribute IP and didn't join the uEPG.(i tried the same thing with VMM, and it's working, but not with physical domain EPG) Br.
Thnx for your reply, No, we didn't enabe PIMv6 under BD and multicast under VRF. Because i think vxrail node just need L2 multicast from ACI. Correct me if i'm wrong.
Hello Sergui, Thanks a lot for your response. I will try that.Your answer makes sense because the intra-EPG traffic from the VM is not even reaching the Leaf (where the Firewall is connected). Maybe my explanation is naive, is there any other good e...
Hi Francesco, We were trying to upgrade to version 4.2(6d) from 2.2(4p), the upgrade via GUI failed on the spine. this spine was showing up inactive on the fabric interconnect. so, we contacted TAC to solve it, he recommended installing a new certifi...
