Hi,
Recently i upgrade cisco firmware from 03.06.04.E. to cat3k_caa-universalk9.SPA.03.06.06.E.152-2.E6.bin after upgraded i couldn't
get into the switch its prompt "SWITCH : "
this is the error i am getting
octeon_loadlinux: bad ELF imageError...
hi, the following command helped me and resolved the issue.
Switch : boot flash:packages.conf
after this command it will load to normal switch mode i.e. "switch>"
there i enabled following commands,
switch>en
switch#conf t
switch(conft)#no boot sy...
Hi Mark,
i cant run these command in "Switch : (Romman mode)"
i can login into the switch by "switch: boot flash:packages.conf"
please find the output
sw1#verify /md5 flash:cat3k_caa-universalk9.SPA.03.06.06.E.152-2.E6.bin
......................
Hi gpauwen,
Thanks for your reply.i have tried this command.
Switch(config)#boot system flash:cat3k_caa-universalk9.SPA.03.06.06.E.152-2.E6.bin
Issue not resolved.
Thanks