Hi community, I think I missed a configuration line for HSRP. The question is, how the multicast-packets of hsrp v2 are communicated if the hsrp members are configured within a physical subinterface. Setup:Fortigate500E Port9 =(like Portchane...
So I found a way that I can connect both physical port without an extra device. The both remote ports on the Fortigate can be connected as a switch, so the Fortigate can have a virtual port there do be addressed and the nexus-switches can see each ot...
As shown in one of the first posts I configured "encapsulation dot1q 27" on both interfaces. I was observing, that the firewall is getting VLAN encapsulated packets. So packets really leave the Nexus with flag Vlan 27. Because both subinterfaces are ...
N7K-1# show run interf eth3/48interface Ethernet3/48description RT-IT-FW-4_CHKno switchportno shutdownN7K-1# show hsrp interface ethernet 3/48.27Ethernet3/48.27 - Group 27 (HSRP-V2) (IPv4)Local state is Active, priority 105 (Cfged 105), may preemptFo...
I am not able to ping within Vlan 27, while VPC says VLAN is up. Well, I can route over VLAN20, so Vlan 27 is reachable, but for multicast addresses this doesn't work - besides this isn't a nice setup.Also strange, the Fortigate only answeres one of ...