I am trying to set QoS values on an MX200 endpoint to AF41 (decimal 34) for audio/video packets. I entered the values in the GUI and it saved OK. A sniffer trace shows the packets still marked as Best Effort DSCP=0. I tried a system restart f...
I think your article is technically accurate in the context of SPB-V.I was wondering if you would consider revising your article to include a comparison to SPB-M?I think it might stack up better in the conclusion.Thanks,Tom Phoenix
BIngo. The remote is a VoIP site with auto-QoS enabled on the 3750 switch where the MX200 connects.I added the trust DSCP to the port config and traffic gets back to HQ marked properly.I was capturing between the switch and router.Thanks to all who ...
Good point Garvan... the sniffer is at the HQ site and the MX200 is behind a remote WAN router that is not supposed to be marking the traffic.I verified the sniffer trace with a tcpdump behind the remote router (remote LAN side) with the same results...