We are running a Cisco 2960x switch. We have multiple PoE enabled devices attached. These devices typically draw 6W. The devices can also be powered by a DC input, at which point they switch to DC power. When running via DC the switch shows that they...
I can't find the console USB drivers on your website. All of the documentation I find says to download it from the support page for the product, 2960 Catalyst, but I can't find the support or download page.
Then I'm missing something because when I try to initiate an applet I get an invalid input error, see below. Switch#configure terminalEnter configuration commands, one per line. End with CNTL/Z.Switch(config)#event manager applet DC-IN-POE-OFF ...
After wasting an afternoon found this statement online, "EEM is not supported on the 2960 series. Only EEM-Lite is supported".I am unable to program applets into my 2960, I am running 15.2 (2) E7.Also noted in this Cisco thread: https://community.c...