I'm doing a proof of concept using Cisco's IOS CA Server to do our DMVPN authentication. When I use a stand alone CA Server this stuff works great but that doesn't have any "redundancy" in it were we to have a failure. So we want to use the subordina...
Currently I'm implementing a CS-MARS solution where the first task is to get it successfully monitoring our logging from WCS. Unfortuantely MARS doesn't support WCS and requires a custom parser to be built so that it understands the logs.I was wonder...
We've noticed a significant difference in how fast packets make it through our network (Website load times mainly) since we upgraded to 3.1.4 on our FWSM.Anyone else experience that?
I've got a native IOS 6509 running 12.1(20)E2 code that I would like to get netflow from on a layer 2 port.Poor setup of the network dictates this need but if it can't be done I'll simply have to fix the network I guess (Painful)Here is the config I ...
I've done a few simple wireless installations based on the AP1231 in the past but right now I'm looking to do a medium sized one. The building is about 225 feet end to end and about 70 feet wide. I've got three floors and would like to provide 54mbps...
I certainly will contact them but I believe the support is in the Gen2 systems which were not available at our time of purchase.So now, we have a Gen1 system and no support for the purpose of the purchase.
I could see what you are saying if we were talking about quarters but we aren't, we're talking about years. Cisco bought protego more than 2 years ago. I'm not sure how long they have had the wireless but it is also more than a year. Somehow we were ...
Well I upgraded to 12.4(16)LD and there is no change in my results. If I remove the revocation-check then it authenticates properly.Of course that's lame though because without that my revoked certificates will not be denied access.
I've just found some notes here:http://www.cisco.com/en/US/customer/products/ps6660/products_white_paper0900aecd805249e3.shtmlThey indicate that I may need to be using 12.4(11)T or better to get the Sub-CA thing working properly.I'll try that tomorro...
Incidentally this is my primary source for documentation of this process:http://www.cisco.com/en/US/customer/products/ps6441/products_configuration_guide_chapter09186a008051eafa.html#wp1144411
