I am finding the wiring for the new EQ Codec is not documented in much detail - Can anyone point me to the correct place... The mic array install doc suggests a switch but doesn't show all the wiring options.Do I need two switches as per below or can...
Does this cable (CAB-USBC-AC-9M=) connect to the port labeled with the spanner (Blue dot on snippet)I assume a recent firmware update enables this cable to work? Snippet from this dochttps://www.cisco.com/c/dam/en/us/td/docs/telepresence/endpoint/roo...
Hello I am being told by a consultant that this will work and I am looking for conformation that it is supported in the latest Cisco Codec Plus firmware?In the Codec Plus Admin guide (https://www.cisco.com/c/dam/en/us/td/docs/telepresence/endpoint/ce...
Hey I want the second output to show exactly the same feed as the main output. Just as a 1 in 2 out video distribution amp would do. Will the software allow me to do that right out the box with no additional licence? Isaac
Hey. My first post! How would I best wire these three cameras up to the SX80 in terms of PTZ control? Scenarios is the P60 is to be installed down at eye level under dual screens.The two 12x cams are up high on poles upside down to capture at the le...
It is possible, we did it. We had to use a Crestron RMC4 for Mute status sync between VC and the MXA910 mics though.Programmer had set RMC to subscribe for mute status from Cisco codec, then send command to Biamp, to mute mics.
Thanks for the links. Really useful.I have since found that BYOM is not required but only content sharing via this cable CAB-USBC-AC-9M=)..Would simply Content share from a laptop into the codec pro work using the ciscoCAB-USBC-AC-9M=) cable?
Looks like the settings for what each monitor outputs are as the below.I have looked at it yea and the only way i can think of making both HDMIs output the same is by setting the outputs as per the below. I can not see that it will be allowed though?...
