About BrijeshYadav24402

BrijeshYadav24402 · 09-09-2021

Hello Team,I am facing issue in IP Netflow Exporter Packet sending problem in C2960X. Records are added and client send packets but exporter not sending to Netflow Stealthwatch device. SW1#show flow exporter statisticsFlow Exporter NETFLOW_EXPORTER:P...

BrijeshYadav24402 · 08-17-2021

Hello Team, Kindly share the understanding of "Application performance assurance issues" in Cisco Prime Infrastructure. And how to find this through on gui or cli. podasrinivasulu@gmail.com

BrijeshYadav24402 · 07-19-2021

Dear Team, Kindly help to find the root cause of Nexus 9K C93180YC-FX Device Unsupported error showing on Cisco Prime Infra 3.4, however, Nexus 9K 9508 device has no error.

BrijeshYadav24402 · 04-23-2021

Team, Kindly suggest the solution that how we configure AP mode and HA between two different locations 1 WLC 9800 at each location. @

BrijeshYadav24402 · 12-19-2020

I am not be able to enable the TKIP for WPA2 with Wave 2 access points and controller firmware above 8.5.xx Please find waring message seen. Warning! WPA2 TKIP cipher is not supported on Wave2 APs for WLAN 2 Please share the all possibility to enable...

BrijeshYadav24402 · 09-09-2021

FYI, flow record FLOW_RECORD_inputdescription NetFlow input record format to send to SWmatch datalink mac source address inputmatch datalink mac destination address inputmatch ipv4 tosmatch ipv4 protocolmatch ipv4 source addressmatch ipv4 destination...

BrijeshYadav24402 · 09-09-2021

Yes find the same-Model-WS-C2960X-48FPD-LVersion- 15.2(7)E3Netflow version- 9Config**** flow record FLOW_RECORDmatch ipv4 source addressmatch ipv4 dest addressmatch ipv4 protocolmatch tra source-portmatch tra dest-portmatch ipv4 tosmatch int output...

BrijeshYadav24402 · 09-09-2021

Dear Balaji,Your example is correct but below command not working-"match interface output". SW1(config-if)# ip flow monitor IPv4_NETFLOW sampler NETFLOW output (input working*)% Flow Monitor: 'IPv4_NETFLOW' could not be added to interface...

BrijeshYadav24402 · 07-21-2021

In some previous years, I think this model was supported but is currently unsupported. But not an issue thanks to all @marce1000 @Leo Laohoo for your prompt supports and reply.

BrijeshYadav24402 · 07-19-2021

No, @Leo Laohoo Current both devices ( Nexus 9K C93180YC-FX & 9508) image version is version 7.0(3)I7(8).

Member Since	‎10-27-2020 05:02 AM
Date Last Visited	‎10-13-2021 09:06 PM
Posts	15
Total Helpful Votes Received	10

User Statistics

User Activity

IP Netflow Exporter Packet sending problem in C2960X Switch

Application performance assurance issues in Prime Infrastructure

Nexus 9K C93180YC-FX Device Unsupported on Cisco Prime Infra 3.4

High Availability Solution Using 1+1 WLC 9800 on different different location.

TK IP encryption enable issue in AIR-CT3504-K9

Re: IP Netflow Exporter Packet sending problem in C2960X Switch

Re: IP Netflow Exporter Packet sending problem in C2960X Switch

Re: IP Netflow Exporter Packet sending problem in C2960X Switch

Re: Nexus 9K C93180YC-FX Device Unsupported on Cisco Prime Infra 3.4

Re: Nexus 9K C93180YC-FX Device Unsupported on Cisco Prime Infra 3.4