Hello,
I have two VSS systems, core_01 and core_02, connected with a port channel. Can I use this port channel with epagp for dual active detection of both systems?
Something like this:
core_01:interface port-channel 20 switchport switchport tr...
Hello,I need to adjust the TCAM memory allocation on a Catalyst 6500 in VSS mode. The two supervisors are VS-S720-10G and the IOS is the version 15.1(2)SY4a.From what I understand, after giving the command "mls cef maximum-routes ip xxx" is necessary...
Hello,I'm using a cisco 6500 with a VS-S720-10G supervisor and a WS-X6704-10GE card. IOS version 15.1(2)SY4a.I need to test a new 10G link. The other end have a loopback cable and my local interface is configured as L3 interface with an IP address. ...
Hello,This morning I tried to activate the TCAM adjustment with the command "mls cef maximum-routes ip xxx".The first test was to restart a switch at a time with the commands "redundancy reload peer" and "redundancy force-switchover". The TCAM memory...
Hello Mark,I scheduled a maintenance windows next week, so I can try both the solutions. Rebooting one switch at a time and eventually the entire switch (two units).I'll post the results.Andrea
Mark,thanks for your answer.But I need to know if reloading one switch at a time (with redundancy commands) enables the TCAM Allocation Adjustment or not.Thanks,Andrea