Hi Cisco Community, I am running SD-WAN lab (version 20.3.2) in EVE-NG and I was in the point where all WAN edges are properly registered to the vManage. However, I noticed that during some time, the DTLS connection or just the transport connection i...
Hi Cisco community, Just wondering if anyone here experienced an ASA5525-X running FTD image being removed in FMC for some reason? I have ran the command "show managers" from the CLI and it says "No managers configured". No changes on it but I'm curi...
Hi Team, I am currently setting up an SD-WAN home lab and fortunate enough our organization has download/access rights to get a copy of necessary images to run in an EVE-NG environment. However, as I came across in getting vEDGE setup, I went to the ...
Hello guys, Wondering if someone can help with the current scenario. To explain further, I'll try to summarize in each normal and backup condition. I'll just put an example of just (2) sites; but in reality there are other remote sites connecting to ...
Hello, We have an old controller 5508 in HA that has couple of 3700s and 3500s AP and we have a new 9800 up and running. We know that the 3500 APs are not supported in the new 9800 and we are going to replace them with 9130 models. Now, there is an e...
@Octavian Szolga Thanks for the response. I may need to test this on new version.Also, one observation is that the default route is being removed for some reason on VPN 0 - thus, unable to communicate to the controllers. This happens when the next-ho...
BTW, I don't see any relevant audit logs that did it. So I'm still wondering why it was lost. The only issue is we have a intermittent WAN issue which is on inside network of the FTD.
Hi @Chakshu Piplani , thanks for the inputs. Just wondering, if the re-registration would push a blank config to the device, will it wipe out all configs including basic IP configuration? And then after the re-registration to the FMC, after re-deploy...
Overall, this is what I'm looking to configure on ASA tunnel-group SSL_VPN type remote accesstunnel-group SSL_VPN general-attributes address-pool VPNPool authorization-server-group ISE-NEW accounting-server-group ISE-NEW default-group-policy cli...
Thanks for the very quick response @Milos_Jovanovic . Really appreciate it.There's some question that I think is not yet answered relating to our existing "secondary-authentication-server-group" for DUO - 2nd password field during client initializing...
