I have two issues that I can't find the answer for online. I had to swap out two line cards (a 10/40 gbps ethernet module and a 1/10 gbps moudule.)Both modules are green and have a status of "ok." The 10/40 gbps module's interfaces came up and I allo...
I think I may have fat fingered the username/password when setting up my Catalyst 3850. I found password recovery instructions. However when I type the command "SWITCH_DISABLE_PASSWORD_RECOVERY=0" I get an error saying that it's read only. Can someon...
I would like to send default traffic from a VLAN out one egress interface and traffic from the same VLAN with an RFC1918 destination out another interface. The problem is, the WAN device is a Meraki and I dont think that I can use prefix lists and ro...
There's a crypto map that already existed and I edited one of the entries to change the diffie-hillman group and the lifetime. The SA table doesn't show the change. Do I need to delete that entry in the crypto map and then recreate it? Here's the cry...
Thanks for the response. For the subinterfaces, I was trying to add them to VDC 2 but was unable to. I then tried to force them back to just look like one interface and was unable to do that as well. I just moved the cable to another interface and sp...
@Richard Burts, yes that is the question. I'm not that experienced here, so bare with me. I know there's policy routing but I'm not sure if it can be applied here. The network is in China. There are two links, one MPLS and the other is connected to a...
No the tunnel has never been up before. There's an extended access-list on the port. I'm assuming the issue might be there. If I add a sequence to permit esp from their host and udp-eq isakmp I'm hoping that it will come up.
