About wendell.bennett@nscglobal.com

wendell.bennett@nscglobal.com · 05-19-2012

Hi,I am using the its-CISCO.2.0.3.0.tcl script to receive a call on a specific dial-peer. When it is hit it is playing the welcome prompt, but if I try to dial any extension no it's not even waiting for the 2nd digit it's saying destination is not re...

wendell.bennett@nscglobal.com · 06-26-2016

This has been resolved now. I found on the console that the jtapi user credential was wrong on the pg configuration.

wendell.bennett@nscglobal.com · 06-16-2016

Hi Shahzad, I must say excellent document. It has helped me a lot to kick off my journey in UCCE. I've been following the entire series and have done whatever is explained. Unfortunately I'm unable to get my CTI Route Point registered, believe that'...

wendell.bennett@nscglobal.com · 09-16-2013

I've a kind of similar issue with same load file. Whenever the PC connected with the PC Port of the phone (6941) is turned on or off the phone goes unregistered. It comes up when the network cable of the phone is disconnected and connected back to t...

Member Since	‎04-30-2012 01:05 AM
Date Last Visited	‎09-28-2022 12:01 AM
Posts	2

User Statistics

User Activity

TCL Script unable to transfer call (its-CISCO.2.0.3.0.tcl)

This has been resolved now. I

Hi Shahzad,

IP Phone 6921(sccp 9.3.3.2) Automatically Unregistered after con