About Mesho7

Mesho7 · 01-08-2021

I would like to understand the concept of Cisco MPLS Tunnels comparing to Huawei Tunnels.Huawei way:1. User configures tunnel-interface which describes interface itself and unidirectional tunnel which starts on this interface. All attributes of the I...

Mesho7 · 12-10-2020

Is MPLS-TE Tunnel considered as Uni- or Bidirectional ?Can the user configure MPLS-TE Tunnel in forward direction different than in backward direction ?

Mesho7 · 11-19-2020

I have a question about MPLS Interface attributes.In the examples I see: Interface LDP Tunnel Enabled -------------------------- -------- -------- -------- POS0/4/0/0 Yes Yes Yes Interface - which ...

Mesho7 · 01-08-2021

Just additional question: if these two MPLS-TE Tunnels are different from each other (one of the attributes bandwidth, setup or hold priority, lockdown, affinity value is different) then is it possible to route one bidirectional Pseudowire over them ...

Mesho7 · 12-10-2020

I was rather referring to the structure of the MPLS-TE Tunnel.I mean, to configure the MPLS-TE Tunnel we need to configure the TE Tunnel Interface and this need to be done in both directions. Is it possible to configure tunnel in one direction differ...

Mesho7 · 11-19-2020

I still don't get the difference between:LDP - State of LDP labelling.Tunnel - State of LSP Tunnel labelling. Interface POS0/4/0/0: LDP labelling enabled LSP labelling enabled (TE-Control) MPLS enabled MTU = 4474

Member Since	‎11-19-2020 02:37 AM
Date Last Visited	‎01-08-2021 12:17 AM
Posts	6

User Statistics

User Activity

MPLS Tunnel

MPLS-TE Tunnel

MPLS Interface attributes

Re: MPLS-TE Tunnel

Re: MPLS-TE Tunnel

Re: MPLS Interface attributes