About brunosredes

brunosredes · 01-09-2018

Hi guys, how is it going? I would like to ask your help and present you a challenge: In a CUCM 10.x environment, when my users call '8000' I need that: - 1st option: Calls are routed to other PBX system (a SIP gateway connected to CUCM); - 2nd opti...

brunosredes · 03-18-2012

Hi friends,Does anyone know if a KS works exclusively as "authenticator" or if a KS works as a encrypter same a GM?Thanks,Bruno Brito

brunosredes · 01-16-2012

Hello,I have a problem with the ACS 5.2 configuration: I am trying to use the AAA authorization to centralize privileges and commands but only the privilege level is sent to router, the command set aren't sent.The test cenary is this:ACS 5.2Router 29...

brunosredes · 05-22-2012

Hi, I use this configuration:Router (g0/1) ---------- (f0/1) SwitchSwitch (f0/2) ---------- (eth) ADSL ModemSwitch (f0/3) ---------- (eth) ADSL Modem:: ROUTER CONFIGURATION ::interface GigabitEthernet0/1 no ip address ip virtual-reassemblyinterface G...

brunosredes · 01-16-2012

Thank you. I liked the idea and will do so.

brunosredes · 01-16-2012

Ok. I did understand, but is there any way of automaticaly load this from ACS?Thanks,

Member Since	‎01-16-2012 02:53 AM
Date Last Visited	‎01-19-2018 12:08 AM
Posts	6

User Statistics

User Activity

Call routing preference using voicemail as a backup

KS - GET VPN

ACS 5.2 - Command set is empty "[ CmdAV= ]"

Assigning multiple ADSL to GE ports

Re: ACS 5.2 - Command set is empty "[ CmdAV= ]"

ACS 5.2 - Command set is empty "[ CmdAV= ]"