antonio.sobreiro
Level 1
Level 1
Member since ‎11-04-2002
‎08-18-2017

User Statistics

  • 19 Posts
  • 0 Solutions
  • 13 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
10 Replies
5 Replies

User Activity

Hi,I have a CAT6509 whith a FWM (firewall module). I have two ways to access the FWM - by ssh or telnet into the CAT6509 and then I do the command session (fwm slot).My question is:is it possible to disable the session (fwm slot). That is I only want...
Hi,I´m configuring the MSFC2 of a CAT6509 but when a try to config a standby groups the MSFC2 gives the following message "More than 16 standby groups not supported in this platform". But I have another CAT6509 in another buillding with more than 16...
Hi,I have a CaAT 2950 and I want to configure port security on Fast Eth ports.I´ve done the following config:interface FastEthernet0/1 switchport mode access switchport port-security no ip address spanning-tree portfastIn the documentation in Cisco t...
Hi,can anyone please tell me what is the CatOs and IOS for the new Catalyst 6509 FW Module (FWM).ThanksRegardsAntonio Sobreiro
Hi,I have 2 cisco PIXs with the last sw 6.2. The are in failover and they have have also stateful failover (with RJ45 cable). When the primary PIX goes down and the secondary goes up(than it becomes the primary) all connections stay alive unless the ...
Community Statistics
Member Since ‎11-04-2002 06:19 AM
Date Last Visited ‎08-18-2017 03:50 AM
Posts 19
Helpful Votes Given To